Description

Mixture of pigments, fillers, plasticizers, solution of epoxy resin in organic solutions and hardener.

Color – red-brown, grey.

Safety information

Hardened film is non-toxic and flame-resistant.

Additional info

Preparation of the surface
To clear it from dust, mud, ferrous oxide, corrosion and other contaminations with any mechanical way, clean off the grease with solvents Р-4, Р-646 or Р-647.
Preparation of the filling
Before application, it is thoroughly mixed with hardener in ratio, mentioned in the COA for the certain lot of the product.
Drying (if temperature is lower than 20 °С) is slowed essentially.
Application
Filling is put with pallet (air-atomization or non-air atomization methods). Before filling is applied with air-atomization method, it is diluted to application viscosity 18-20 сс according to viscometer ВЗ-246 (or ВЗ-4), nozzle diameter of which is 4mm, with solutions Р-5А, Р-5 or Р-4. The prepared filling is applied on the protected surface at temperature of environment that is less than 5°С and relative humidity of air that is not higher than 80%. In order to avoid compensation of moisture, surface temperature should be higher at not less than 3°С than dew point temperature is. After full drying of the layer (24 hours at 20°С), surface of filling is grounded and cleared from dust; then other layers of filling or other paint materials are applied. In order to wash a tool, on should use above-mentioned solutions
Consumption rate for one layer while using a pallet is up to 690 gm². Thickness of one layer while using a pallet is up to 350 um.
Consumption rate for one layer while using an airbrush — 120-295 g/m². Thickness of one layer while using an airbrush is up to 60-150 um.
The recommended quantity of the layers while using a pallet is 1 and while using airbrush is 2-3.